Pinions and gears
Pinion 1
Pinion shaft assembled on a rolling mill gearbox with ball bearings.Turning, toothing, grinding, machining and bearing assembly performed.
Material: cast steel with heat treatment only for toothing.
Dimensions: L 3200 mm x Ø 920 mm.
For a rolling mill line in Italy.
Pinion 2
Pinion shaft assembled on a rolling mill gearbox.Turning and toothing machining performed.
Material: cast steel, only quenched on the toothing.
Dimensions: L 3500 mm x Ø 1200 mm.
For a rolling mill line in Italy.
Pinion 3
Pinions and gears assembled on rolling mill gearbox.Turning and toothing machining performed.
N.01 Conical couple with Gleason Spiral toothing.
N.01 Winding couple with bihelicoid toothing.
For a rolling mill line in Luxembourg.